REVIEW ON ABRASIVE JET MACHINING OF TITANIUM ALLOYS
Chandrakant Chaturvedi
ME Scholar, Mechanical Engg. Department, NITTTR, Chandigarh , IN
Dr P Sudhakar Rao
ME Scholar, Mechanical Engg. Department, NITTTR, Chandigarh , IN
Keywords: Titanium alloy, Abrasive water jet (AWJ), Control depth milling CDM
Abstract
Titanium alloy which comes under the category of very difficult to machine material by conventional machining processes because of it’s extremely short tool life. Titanium is a lightweight metal a widely used aircraft structural titanium alloy (Ti-6Al-4V) was machined with an abrasive water jet (AWJ) since other processes such as chemical machining have environmental legislative restriction and higher cost associated with waste disposal. Various parameters associated with abrasive waterjet machining while machining titanium alloy has been analyzed in this review and provision for further improvement has been considered
How to Cite
References
NA