CHANGE IN MATERIAL REMOVAL RATE WHILE USING “MAGNETO ABRASIVE FLOW MACHINING”

Authors

  • TARUN JAGGA Department of Mechanical Engineering, Geeta Engineering College, Panipat
  • MR. JITENDER KUMAR Assistant Professor, Department of Mechanical Engineering, Geeta Engineering College, Panipat

Keywords:

Magneto Abrasive Flow Machining (MAFM), Material Removal Rate, Abrasives, Machining, Finishing, Taguchi method

Abstract

In this paper, we will discuss the effect of change in material removal rate of Magneto Abrasive Flow Machining. Abrasive flow machining is a mechanized method that is surge of under pressure coarse medium to eliminate work piece substance and get better outer surface unevenness. AFM is extremely proficient and appropriate for finishing of complicated internal surfaces and hard getting in touch with surface. In the current study the consequence of variant input constraints on MRR has been explored with Taguchi analysis. An investigational study was performed on Aluminium work piece. The coarse size, characteristics of carrier, number of cycle and abrasive deliberation are main constraints that have an effect on the performance of AFM. The purpose is to study the consequence of procedure variables on material removal rate.

Downloads

Published

2021-10-23

How to Cite

JAGGA, T., & KUMAR, M. J. (2021). CHANGE IN MATERIAL REMOVAL RATE WHILE USING “MAGNETO ABRASIVE FLOW MACHINING”. International Journal of Technical Innovation in Modern Engineering & Science, 6(9), 36–43. Retrieved from https://ijtimes.com/index.php/ijtimes/article/view/103

Issue

Vol. 6 No. 9 (2020): Vol. 6 No. 9: Volume 6 Issue 9 (September-2020)

Section

Articles