A review Paper on Deformation machining

Authors

  • Harshil Tandel Research Scholar Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India
  • Dr. P.M. George Professor Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India
  • C.P. Mazmudar Assistant Professor 3Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India

Keywords:

thin section machining, deformation bending, thinning, monolithic component, deformation forming

Abstract

DM is amalgamation of two processes-namely thin wall machining and single point incremental bending/forming. This process allows the formation of complicated geometries and structures, which would be rather difficult or on occasionunmanageable to manufacture. This process allows the formation of monolithic components with  uncommon geometries which were earlier assembled. DM allowsformation of monolithic structures with complicated geometries employing conventional tooling.

Downloads

Published

2018-05-28

How to Cite

Tandel, H. ., George, D. P., & Mazmudar, C. . (2018). A review Paper on Deformation machining. International Journal of Technical Innovation in Modern Engineering & Science, 4(5), 186–190. Retrieved from https://ijtimes.com/index.php/ijtimes/article/view/1438

Issue

Vol. 4 No. 5 (2018): Vol. 4 No. 5: Volume 4 Issue 5 (May-2018)

Section

Articles