SECONDARY TREATMENT OF PAPER AND PULP WASTE WATER BY USING SEQUENTIAL BATCH REACTOR (SBR)

Authors

  • Preethijohnevelin.S Assistant Professor, Department Of Civil Engineering, Kgisl Institute Of Technology
  • Evanjeline Libie.P Assistant Professor, Department Of Civil Engineering, Kgisl Institute Of Technology

Keywords:

SBR, COD, BOD, Optimization Cycle

Abstract

The Paper and pulp mill waste water was collected from the ITC paper mill, Meetupalayam and it is
immediately used for the experiment conducted using SBR. The following experiments were conducted to determine
the efficiency of the SBR system in treating the waste water. (I) Initial characteristics of the wastewater were
determined (ii) Determination of COD removal efficiency (iii) Determination of BOD removal efficiency (IV)
Determination of TSS removal efficiency. The Initial characteristics of waste water were: TSS 460 mg/l, pH 6.73,
BOD 52 mg/l, and COD 2140 mg/l. The Following Parameters are varied (I) Temperature (II) Aeration rate.

Downloads

Published

2019-03-31

How to Cite

Preethijohnevelin.S, & Evanjeline Libie.P. (2019). SECONDARY TREATMENT OF PAPER AND PULP WASTE WATER BY USING SEQUENTIAL BATCH REACTOR (SBR). International Journal of Technical Innovation in Modern Engineering & Science, 5(18), -. Retrieved from https://ijtimes.com/index.php/ijtimes/article/view/3205

Issue

Vol. 5 No. 18 (2019): ICRESET-2019 (International Conference on Recent Explorations in Science, Engineering and Technologies)

Section

Articles