DEVELOPMENTS IN WORKHOLDING DEVICES – A REVIEW

Authors

  • Sukhwinder Singh Department of Mechanical Engineering, National Institute of Technical Teachers Training & Research Chandigarh, India – 160019
  • Deepam Goyal Department of Mechanical Engineering, National Institute of Technical Teachers Training & Research Chandigarh, India – 160019
  • BS Pabla Department of Mechanical Engineering, National Institute of Technical Teachers Training & Research Chandigarh, India – 160019

Keywords:

Jigs and Fixtures; Machining; Flexible Manufacturing System; Reconfiguration

Abstract

With the advancement in the latest technologies and the competitiveness in the market of the modern era, the custom design fixtures for a specific workpiece are very time consuming and expensive to manufacture, but also they are not having the enough flexibility to tackle with the components or assemblies of the different geometry and sizes. This is truly an unwilling situation in the manufacturing to deliver a wide variation in the parts or products for the marketplace. Hence, the selection of appropriate holding devices affects the cost and quality of manufactured components. This paper presents the state-of-the-art review on developments in the fixtures for flexible manufacturing.

Downloads

Published

2021-11-24

How to Cite

Singh, S., Goyal, D., & Pabla, B. (2021). DEVELOPMENTS IN WORKHOLDING DEVICES – A REVIEW. International Journal of Technical Innovation in Modern Engineering & Science, 5(3), 344–348. Retrieved from https://ijtimes.com/IJTIMES/index.php/ijtimes/article/view/2447

Issue

Vol. 5 No. 3 (2019): Vol. 5 No. 3: Volume 5 Issue 3 (March-2019)

Section

Articles