POWER QUALITY IMPROVEMENT USING SINGLE PHASE FRONT END CONVERTER

Authors

  • Dr. Premananda Pany Department of Electrical and Electronics Engineering
  • Abdulsalam Umar Department of Electrical and Electronics Engineering
  • Sumaya Farjana Department of Electrical and Electronics Engineering

Keywords:

Front End Converter, SPWM, PID Controller, Simulink

Abstract

This paper presents the design and simulation of single phase front-end converter in order to improve the
power quality in terms of the power factor and reduces harmonics by implementing a close-loop control method. The
line voltage is also to be boosted using a boost inductor. In all inverter controlled drive applications and in wind power
conversions, the use of two stage power conversion i.e. power conversion from AC-DC and DC-AC is unavoidable.
For such applications this PWM rectifier can be used for primary AC-DC conversion. Sinusoidal pulse width
modulation (SPWM) method has been used to achieve high power factor and to reduce the harmonics. The simulation
results are presented which is carried out with MATLAB/ Simulink.

Downloads

Published

2019-04-30

How to Cite

Dr. Premananda Pany, Abdulsalam Umar, & Sumaya Farjana. (2019). POWER QUALITY IMPROVEMENT USING SINGLE PHASE FRONT END CONVERTER. International Journal of Technical Innovation in Modern Engineering & Science, 5(14), -. Retrieved from https://ijtimes.com/index.php/ijtimes/article/view/3091

Issue

Vol. 5 No. 14 (2019): AESMT-2019 (Advancements in Engineering, Science, Management, and Technology)

Section

Articles