A review Paper on Deformation machining
Harshil Tandel
Research Scholar Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India , IN
Dr. P.M. George
Research Scholar Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India , IN
C.P. Mazmudar
Research Scholar Mechanical Engineering Department, BVM Engineering College, V.V.Nagar, Anand, Gujarat, India , IN
Keywords: thin section machining, deformation bending, thinning, monolithic component, deformation forming
Abstract
DM is amalgamation of two processes-namely thin wall machining and single point incremental bending/forming. This process allows the formation of complicated geometries and structures, which would be rather difficult or on occasionunmanageable to manufacture. This process allows the formation of monolithic components with uncommon geometries which were earlier assembled. DM allowsformation of monolithic structures with complicated geometries employing conventional tooling.
How to Cite
References
NA